LLG Catalogue
Built-in hotplates series EB-C, CERAN®
The EB-C series is designed for table installation, and is supplied with installation suspension. The separate controller housing can be installed directly into the table frame. Electrical connections between controller housing and hotplate are protected by a flexible metal hose. Conductor length between controller housing and hotplate 0.65 m.Heated area marked on CERAN® heating surfaceNo heat loss to table top and heating surface edges
Bunsen burner for cartridge
With needle gas valve and air regulator.Only for the gas cartridge 9.018 364.
Bunsen burner with air regulation
Burners according to DIN 30665 cannot be switched off completely. A small flame remains burning even if needle valve or stop cock are turned off. The gas flow shall be disconnected by means of the central stop cock in the laboratory.
Bunsen burner with needle valve
DIN 30665. Air regulation, pilot flame.Rubber sucker base (Art. Nr. 9.018 360) please order separately.
Bunsen burner, Ms-Ni
With needle valve DIN 30665. Air regulation, pilot flame, max. 1300°C. An anti-slip rubber coating under the base ensures absolute stability.
Bunsen burner, portable Labogaz® 206
For operation with gas cartridge C 206 GLS (Cat.-No.: 9.018 520). DVGW-authorised.
Bunsen burner, portable, Labogaz® 470
For operation with gas cartridges CV 300 Plus (Cat.-No.: 6.243 905) or CV 470 Plus (Cat.-No.: 9.018 512).
Bunsen burners
Bunsen burner with needle valve and pilot flame DIN (NG-2411 BO0031).
Bunsen burners with air regulator and needle valve
With air regulator and needle gas valve. Adjustable nozzle.
Burette and thermometer clamp
"Automatic". Sprung-clip jaws with chrome-plated shaft.
Burette and thermometer clamp
"Automatic". With bosshead 13.5 mm, Aluminium chrome-plated, self-closing. Shaft length 40 mm.
Burette bottles, borosilicate glass 3.3
Burette bottle for automatic burettes is made from heat resistant glass. Each bottle has a NS 29/32 neck grinding that fits to burette.
Burette clamp
Polypropylene. Bosshead supplied with two adapters so that the clamp can fit on to support rods having diameters 8 to 14mm. Stainless steel spring loaded centre arm holds burette firmly against the two outer arms and is protected by rubber grips. Graduations and meniscus are visible at all times. Suitable for all burettes.
Burette clamps
With bosshead. Zinc die casting, nickel-plated. Vinyl-coated jaws.
Burette clamps, aluminium die casting
For burettes up to 50 mlPVC-coated clamps provide a secure gripComfortable height adjustmentIntegral support connector
Burette clamps, nickel plated brass
Burette clamp with boss, nickel plated brass, for 1 burette.
Burette clamps, nickel plated brass
Burette clamp with boss, nickel plated brass, for 2 burettes.